[. . . ] Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible. The cable must be checked regularly and replaced by authorised technicians only (see Assistance). The manufacturer declines any liability should these safety measures not be observed. 10 Description of the appliance Overall view The instructions contained in this manual are applicable to different model refrigerators. [. . . ] If the room temperature drops below 14°C for an extended period of time, the ideal temperature will not be reached in the freezer compartment and food preservation will be reduced. 13 Maintenance and care GB Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: It is not sufficient to set the temperature adjustment knobs on (appliance off) to eliminate all electrical contact. Defrosting the freezer compartment If the frost layer is greater than 5 mm, it is necessary to defrost manually: 1. Set the TEMPERATURE ADJUSTMENT knob to the position . 2. Wrap frozen foods in newspaper and place them in another freezer or in a cool place. This can be made easier by placing containers with lukewarm water in the freezer compartment. 4. Clean and dry the freezer compartment carefully before switching the appliance on again. until the ideal storage conditions have been restored, before placing food in the freezer compartment. Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. • The removable accessories may be soaked in warm water and soap or dishwashing liquid. Rinse and dry them carefully. Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. • If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Do not use objects with sharp or pointed edges to defrost the appliance as these may damage the refrigeration circuit beyond repair. Defrosting the refrigerator compartment The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. It is necessary to clean the discharge hole regularly so that the water can flow out easily. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (15W or 25W). 14 Precautions and tips !The appliance was designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. This appliance complies with the following Community Directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; -89/336/EEC of 03. 05. 89 (Electromagnetic Compatibility) and subsequent amendments; - 2002/96/CE. Disposal • Observe local environmental standards when disposing packaging material for recycling purposes. [. . . ] • The internal refrigerant makes a slight noise even when the compressor is off. • These raised temperatures are necessary in order to avoid the formation of condensation on certain parts of the product. • This shows the appliance is operating normally. The refrigerator and the freezer do not cool well. The food inside the refrigerator is beginning to freeze. [. . . ]